1. Place the bottle in the middle of the foam with the bottom of the bottle lining up with the edge of the foam.

2. Wrap the foam around the bottle so that the two edges meet in the middle and hot glue them in place.

3. For the excess foam at the top of the bottle, cut a straight line in the middle of the foam down to the bottle.

4. Fold the excess over the bottle on each side and hot glue in place.

5. Using the top of the cap (where it says HERSHEY'S), trace a circle on the second sheet of foam and cut it out.

6. From the rest of the foam, cut out a 1 inch wide strip along the length of the foam. Fold the strip in half lengthwise and cut along the folded line.

7. Wrap one strip around the bottom of the cap and hot glue in place. Cut off any excess. *Make sure to leave space where the cap opens*

8. Wrap the other strip around the top of the cap and hot glue in place. Cut off any excess. *Make sure to leave space where the cap opens*

9. Use the foam paint to clean up any rough edges and decorate.

10. Place stickers on the front and back of the bottle to add your own special touch. TIP: You can use letters to spell your name for a more personalized touch.

11. Fill with water and squirt away!